Settings

Load also the second location when loading cable

A location at the other end of the cable is also loaded into the task.

Load all locations of the sub location levels

When loading a location from any level that is not the lowest level, all locations situated below this location are loaded.

Load components of the back plane layer

Components of the backplane layer are also loaded into the task.

Load assigned cables/ducts

Containers, shafts, are loaded together with allocated cables and ducts.

Load group components

Components built up as group elements are also loaded when loading containers.

Enable element loading

Loads automatically all elements contained in containers

Close tasks on shut down

Reduces start time of ConnectMaster, as the last used task is not automatically loaded

Show description

Displays a description of the objects in the task explorer

Description of all super-locations

Shows the description of higher levels.

Show slot names

Shows names of the MUX slots in the task.

Execute component filter

Start component filter when loading a new component into a task , automatically or manual

Structure

Do all components, including slots and cards, have to be displayed in the filter or only top components like containers and MUX?

Attribute columns

Do the attribute columns have to be displayed in the filter results or not.