Settings

Connect model

Has influence on auto patching actions (Divide cable, insert component), in the path search and parallel path analysis.

Direct
Cable to cable directly connected

Splitting
Cable to panel/Sleeve to cable

Bridge
All cable on one side of the sleeve and on the other side bridges are set

Don't delete F-Text connections with:

Connections that contain a specific F-Text are not deleted.

New

New path settings

Path names unique

Test for unique name

Status

Status for new path

Owner/Used by

Owner/ Tenant for new paths

Attributes

Attribute for new paths

Work orders

Path settings for work orders

New connections

According to which type should new connections be generated

Wire to wire

Execute direct connections between fibers or iignore them

Show location in all rows

Only in the case of a location change or on every component

Show point group:

In which group a point is located

Subsitute empty names

Paths without names can be replaced with characters

Check phys. paths after cross-wiring actions (only temporary)

After patching, the consistency of paths is examined; they are disconnected by CM after restart.